TrackLink: Toy Track to Brick Adapters
Provisional 3D-printable plates that sit under classic orange toy track and press onto LEGO-style bricks, shown here carrying two track segments on brick towers.
About this model
TrackLink is an independent set of printable plates. The top has two tongues that slide into the L-shaped grooves under a classic orange toy track piece, so a plate can be placed anywhere along the underside (no end stop or locking button). The bottom is a hollow LEGO-style clutch underside (skirt and tubes, like a standard plate) that presses onto studded bricks. A second version carries the track on a 10 degree rise.
The model shows two 200 mm track segments end to end. The left one sits flat on a System plate over a 3-brick support. The right one rises at 10 degrees on the angled plate over a support with three plate spacers. Checked in CAD: no part intersects another, and the track slides along the plate tongues without collision. The track segments are simplified visualisation models built from a measured profile, not printable parts.
STATUS: PROVISIONAL, DESIGNED ONLY. Nothing here has been printed or fit-tested. The track profile comes from a third-party reference model, not real track, and clearances, tube diameter and stud height are placeholder estimates. No compatibility, strength or load claim is made.
Not modelled: banked supports, telescoping supports, bridges, track end connectors. This is an independent project and is not affiliated with or endorsed by the makers of the toy track or the brick system.